Showing posts with label Length Matching. Show all posts
Showing posts with label Length Matching. Show all posts

Wednesday, September 3, 2008

Trace Length and Length Matching

Trace length greatly affects the loss and jitter budgets of the interconnection. The PCB trace may introduce 1 ps to 5 ps of jitter and 0.35 dB to 0.50 dB of loss per inch.

For an add-in card, the trace length from the edge finger to the Philips PCI Express PHY pads should be limited to 4 inches. For the system board, the trace length is recommended to be less than 12 inches.

Long distance traces should be routed at an off-angle to the X-Y axis of a PCB layer, in order to distribute the effects of fiberglass bundle weaves and resin-rich areas of the dielectric.
The two traces of a pair should be symmetrically routed.


The length difference between a differential pair should be limited to 5 mils maximum. Length matching is required per segment, and any length added (typically a “serpentine” section) for the sake of matching a pair should be added near the location where the mismatch occurs.
There is no length match requirement between transmit and receive pairs.